WRG1 Module

WRG1 is a low power embedded Wi-Fi module developed by Tuya Smart.

Scope of application

This topic describes relevant information about WRG1 module during MCU connection development.

WRG1 is a low power embedded Wi-Fi module developed by Tuya Smart. The module consists of a highly integrated radio-frequency identification (RFID) chip RTL8711AM and an external flash chip, with a built-in Wi-Fi network protocol stack and various library functions. WRG1 also has low-power ARM-Cortex M3 MCU, WLAN MAC, and 1T1R WLAN. The highest basic frequency is 166 MHz. The module has 2MB built-in synchronous dynamic random access memory (SDRAM), 4 MB flash, and numerous peripheral resources. As a real time operating system (RTOS) platform, WRG1 integrates all function libraries of Wi-Fi MAC and TCP/IP protocols. You can develop your own embedded Wi-Fi products.

For more information, see WRG1 Module Datasheet.

Typical application diagram

• Reference diagram of coordinated processing mode of the module and 3.3 V MCU:

  

• Reference diagram of coordinated processing mode of the module and 5 V MCU:

  

Design specification

• Module power supply:

  • When the module is in the working mode, the maximum transient current reaches 343 mA. It is recommended that the supply current of the 3.3 V module should exceed 400 mA.
  • In the PCB layout, capacitors C1 and C2 at the power input pin shall be arranged near the power supply pin. The capacitance shall exceed 10 uF.

• Module pin:

  • There are no special pins. For more information, see WRG1 Module Datasheet.

• Radio frequency (RF) of the module:

  • When a PCB onboard antenna is used in the Wi-Fi module, it is recommended that the distance between the module antenna and other metal parts should be at least 15 mm, in order to optimize the Wi-Fi performance. Wiring and copper pour are not allowed in the antenna area of the PCB, in order not to affect the antenna performance.

    

    

  • The parameters of U.FL RF connector are shown in the figure below: