Firmware Configuration

Last Updated on : 2024-11-20 08:51:38

This topic describes how to configure firmware for your pet water fountain pump. For more information about product creation, see Create Products.

Parameter type	Parameter	Description
Product pairing options	Pairing reset	The number of restart operations that trigger device resetting for pairing.
Product pairing options	Restore to factory defaults	The number of restart operations that trigger the restoration to factory defaults.
Pump settings	Level-1	I/O configuration of level-1 control.
	Level-2	I/O configuration of level-2 control.
	Level-3	I/O configuration of level-3 control.
	Level-4	I/O configuration of level-4 control.
	Pump type	Distinguish between three-wire and four-wire detection rules, and adapt to different pumps.
	Pump detection 1	I/O configuration of water quantity detection.
	Pump detection 2	I/O configuration of water quantity detection.
	Lack of water protection	In lack of water, the pump will stop rotating by operations on the hardware or software.
Lighting settings	RGB multicolor light-R	I/O and active level settings of a RGB multicolor light.
	RGB multicolor light-G	I/O and active level settings of a RGB multicolor light.
	RGB multicolor light-B	I/O and active level settings of a RGB multicolor light.
	Default lighting color	Restore to the default lighting color.
	UV disinfection light	I/O and active level settings of a UV disinfection light.
	Default disinfection duration	Restore to the default disinfection duration.
Default settings	Working mode	Set the default working mode of the pump, including normal mode and smart mode.
	Gushing duration	Restore to default gushing duration in the smart mode. In the smart mode, gushing and intermittent water flows are performed in a loop.
	Intermittent duration	Restore to default intermittent duration in smart mode. In this mode, gushing and intermittent water flows are performed in a loop.
	Recovery after pause	Restore to the default duration for the pump to resume gushing after a pause.
	Default water yield	Restore to the default water yield. That is, the default level of the pump.
	12-hour or 24-hour clock	Restore to the default rule of showing the time on the app.
	Filter cartridge replacement interval	Restore to the default number of days when a filter cartridge should be replaced.
	Cleaning prompt interval	Restore to the default number of days when a prompt for cleaning is generated.

An initial value should be a valid value within the data point range.