BT3L-A Module

This topic describes Tuya’s proprietary low-power BT3L-A Bluetooth module.

Features

The BT3L-A consists of a highly integrated TLSR8250F512AT32 Bluetooth chip and a few peripheral circuits. It has built-in Bluetooth protocol stacks and a rich set of library functions.

The BT3L-A is built around a 32-bit MCU with 512 KB flash and 48 KB SRAM. It has 9 GPIOs. The embedded 2.4 GHz transceiver supports Bluetooth 5.0 low energy.

For more information, see BT3L-A Module Datasheet.

Typical application circuit

Generic solution

• Connection between a module and a 3.3V MCU

  

• Connection between a module and a 5V MCU

  

Low power solution

• Connection between a module and a 3.3V MCU

  

• Connection between a module and a 5V MCU

  

Level translator reference

• N-channel MOSFET level translator

  In the following circuit diagram, an N-channel MOSFET and a built-in body diode are used to implement two-way communication.

  

• NPN triode level translator

  In the following circuit diagram, an NPN triode is used to implement one-way communication.

  

Design specification

• Power supply

  • The supply current for 3.3V modules should be greater than 100 mA. The total capacity of the external filter capacitor should be greater than 10 μF.
  • Place the filter capacitors of the power input pin near the power pin of the module.

• Pins of the module

  • The module has a power-on-reset circuit. You can also use the GPIO on the MCU to control the module reset. Take care of the voltage level translation.

  • The MCU can pull down or up the low power pin on the module to make the module enter or exit the sleep mode. The configuration is shown below.

    Low power pin	Voltage level in low power	Voltage level in standard power
    TL_B5	Low	High

  • The module can change the level of the wake-up pin for 200 milliseconds to wake up the MCU for serial data transmission. After that, the pin will go back to the default level. The configuration is shown below.

    Wake-up pin	Voltage level on transmitting	Voltage level on idle
    TL_D2	High	Low

• Radio frequency

  The distance between the antenna and other mental components should be at least 15 mm to provide the best radio performance. Placing any metal materials around the antenna can significantly reduce the RF performance.

  Allow enough space to support the RF layout when designing your product.