BMS Box (UART)

Last Updated on : 2023-05-31 10:40:10download

A BMS box (UART) is a cellular-based battery management system (BMS) with a positioning function. It is built with Tuya’s proprietary 4G LTE Cat.1 module LZ501-CN and positioning module GUC300. This BMS box features battery information reporting, battery parameter configuration, remote control, and fault alerts.

Get products

Contact your account manager to request the BMS box.

Feature description

Support for integration with BMS manufacturer’s protocol
Battery data upload
Battery parameter configuration
Remote control of battery
Battery fault alerts
LBS and Wi-Fi combo positioning
Route tracking
Fault alerts
Remote configuration
FOTA firmware updates

Product specifications

Specification	Description
Size	87.2 mm × 40 mm × 19 mm
Weight	About 60g
Communication module	LZ501-CN
Positioning module	GUC300
Antenna	Built-in 4G antenna
Bluetooth antenna	Built-in Bluetooth antenna
Wi-Fi antenna	Built-in Wi-Fi antenna
GPS antenna	25 mm × 25 mm × 4 mm ceramic antenna
Wiring harness	Power supply (red) Ground (black) UART RX (white) UART TX (yellow) UART GND (purple)
CPU	Cortex-A5, 500 MHz
Storage	128 MB RAM, 64 MB ROM
SIM card	Nano SIM or eSIM card
Operating temperature	-25°C to 75°C
Storage temperature	-40°C to 85°C
Power consumption	Active: 5 mA to 7 mA Sleep: 1.3 mA
Sensor	3-axis G-sensor
Power supply IC	9V to 85V DC-DC
LED indicator	Power (red) GPS (blue) Network (green)
Frequency bands	LTE-FDD: B1/B3/B5/B8 LTE-TDD: B34/B38/B39/B40/B41
Maximum rate	Maximum download speed of 10 Mbps Maximum upload speed of 5 Mbps Maximum download speed of 8.2 Mbps Maximum upload speed of 3.4 Mbps

Installation

Instructions on installing 4G BMS box (UART)

Step 1: Install the SIM card.
Step 2: Connect the wire.

Harness description:

Type	Description
Power supply	Red wire, connected to 12V to 85V power supply.
Ground	Black wire, the ground wire.
UART RX (white)	White wire, the UART receiver.
UART TX (yellow)	Yellow wire, the UART transmitter.
UART GND (purple)	Purple wire, the UART ground.

The BMS box comes with a 2-pin power connector and a 3-pin UART connector. You can customize the connectors to match the battery and device.

Prev DocAdvanced Syntax

Next DocBMS Box (Standard)